DeltaQuad Pro operations manual v2
  • Introduction
  • Vehicle specifications
  • Video instructions
  • DeltaQuad Simulator
  • Setup
    • Assembly
    • Battery
    • Telemetry & Ground Control
    • Key parameters
    • Safety features
    • Integrating payloads
  • Flight
    • Radio range and Line of sight (LOS) operation
    • Ground Control Station overview
    • Planning a mission
    • Pre-flight checks
    • Executing and monitoring a mission
    • Manual override
    • Post-flight
  • Maintenance
    • Sensor calibration
    • Firmware upgrade
    • Battery charging and storage
    • Flight logs
    • Preventative maintenance
    • Scheduled maintenance
    • Wiring diagram
  • DELTAQUAD PRO #VIEW
    • DeltaQuad Controller
    • Booster Package and Antenna Installation
    • Controlling the vehicle
    • Controlling the camera
    • Target tracking & following
    • Transmission modes and stream rates
    • Changing camera settings
    • Connecting a second screen
    • Using the Camera Control Laptop
      • Wi-Fi network connection
      • VPN-based connection
      • Controller hotspot connection
  • DELTAQUAD PRO #MAP
    • DeltaQuad Controller
    • Controlling the vehicle
    • Planning survey missions
    • Configuring your camera
    • Geo-referencing
    • Connecting a Secondary Control Terminal
  • DELTAQUAD PRO #INSPECT
    • DeltaQuad Controller
    • Controlling the vehicle
    • Configuring your camera
  • DELTAQUAD PRO #CARGO
    • DeltaQuad Controller
    • Booster Package and Antenna Installation
    • Payload Drop Mechanism
Powered by GitBook
On this page
Export as PDF
  1. DELTAQUAD PRO #INSPECT

Configuring your camera

PreviousControlling the vehicleNextDeltaQuad Controller

Last updated 1 year ago

Your Ground Control Station comes equipped with the app. This app uses Bluetooth to communicate with your Flir Duo Pro R. To connect to your camera make sure you are close to your UAV as the Bluetooth connection has limited range.

When first powering on the UAV, the camera will enable Bluetooth for approximately 1 minute. It will indicate this by a blue light. If the blue light is not solid or blinking, press the Bluetooth button on your camera. The app should automatically detect the camera.

The Flir Duo Pro is not triggered by the flight controller, it needs to be programmed for either distance or time interval triggering. If you wish to perform radiometric mapping with the Flir Duo Pro you will need to take the following steps:

  1. Launch the Flir UAS app

  2. Select the multi-image capture mode with an interval of 1 second

  3. In the settings screen, make sure the function of PWM 3 is set to "start/stop recording"

  4. Start the trigger process by clicking the big blue record button. When using the DeltaQuad Controller, this can be performed in flight by activating the trigger by switching button 8 as described in the section.

For more information on configuring your Flir Duo Pro R for the correct scene and thermal functions, please refer to the or the .

Flir Duo Pro Quick Start Guide
Flir Duo Pro R manual
Flir UAS
DeltaQuad Controller