DeltaQuad Evo ENT operations manual
  • DeltaQuad Evo Enterprise Edition
  • Introduction
  • Vehicle specifications
  • Auterion Suite
    • Create an Auterion Suite account
    • Activating your vehicle
    • Using the DeltaQuad Evo simulator
  • Setup
    • DeltaQuad Evo flight case
    • Assembly
    • Replacing the propellers
    • DeltaQuad Evo battery
      • Battery handling
      • Charging and storing the battery
      • Battery placement
      • Powering the vehicle
    • Safety features
  • Flight
    • DeltaQuad Controller
      • Controlling the vehicle
      • Connecting a secondary Control & Command Terminal
      • Controller factory reset
      • Pairing the DeltaQuad Controller with the air unit
    • Radio range and Line of sight (LOS) operation
    • Ground Control Station overview
      • Fly View
      • Plan View
    • Planning a mission
      • Preparing a mission plan
      • Best practices and tips
      • Mission Start Action
      • Set intermediate waypoints
      • Mission End Action
    • Pre-flight Checks
    • Executing and monitoring a mission
    • Post-flight
  • Maintenance
    • DeltaQuad Evo maintenance kit
      • VTOL Arm change
      • Pusher Motor Pod change
      • Wingtip change
    • Elevon change
    • Sensor calibration
    • Firmware upgrade
    • Flight logs
    • Preventative maintenance
  • DeltaQuad EVO payloads
    • NextVision
      • Raptor
      • Nighthawk2-V/UZ
      • Controlling the camera
      • Connecting a second screen
Powered by GitBook
On this page
Export as PDF
  1. Flight
  2. DeltaQuad Controller

Pairing the DeltaQuad Controller with the air unit

In this section, we will discuss how to bind the DeltaQuad Controller with the DeltaQuad Evo air unit.

PreviousController factory resetNextRadio range and Line of sight (LOS) operation

Last updated 1 year ago

After a factory reset has been performed on the DeltaQuad Controller, it might be necessary to rebind the controller with the air unit located in the DeltaQuad Evo. Please follow the steps below.

  1. Power on the DeltaQuad Evo and the DeltaQuad Controller. Open Auterion Mission Control. In the upper right corner of the screen, the Radio icon is located. If it has a strike-through and the radio link is not available, a rebinding is required.

  1. Remove the hatch of the avionics bay by loosening the two screws with a Torx tool (T10).

Please use a medium-strength lock bond when tightening the screws again.

  1. In the avionics bay you will see the radio modem. Push the SET button. This puts the modem into the bind mode. When in bind mode, the LED of the modem rotates through different colors.

  1. On the Controller, open the Radio Settings app.

  1. Open WIRELESS PARAMETER CONFIGURATION.

  1. Tap on FREQUENCY MATCHING.

  1. Click on Confirm.

After the binding process has been successful, a connection will be established between the DeltaQuad Evo and the DeltaQuad Controller.